- OPEN TRANSPORT MAC OS X MAVERICKS MAC OSX
- OPEN TRANSPORT MAC OS X MAVERICKS INSTALL
- OPEN TRANSPORT MAC OS X MAVERICKS BLUETOOTH
The installation went by flawless and I have installed Mac OSX on my previous two hard drives, but needed an upgrade. I have even tried removing my graphics card and booting off the Intel HD4000 integrated graphics, but still no boot. I have tried countless flags (-v, -x, -f, GraphicsEnabler=Yes/No, PCIRootUID=Yes/No, dart=0), but I am still not able to boot at all.
OPEN TRANSPORT MAC OS X MAVERICKS BLUETOOTH
I verbose boot (-v) and get to the " Missing Bluetooth Controller Transport!" message.Īfter a short time the following appears:įlow_divert_kctl_disconnect (0): disconnecting group 1ĬonsiderRebuildOfPrelinkedKernel prebuild rebuild has expired I have tried everything mentioned but the problem persists (including removing the graphics kexts). **SOLVED - I was able to restore from a Time Machine Backup within the Installer and was able to boot then*** *under safe mode it should list your gfx that were picked up like it showed me, that's how I knew what to eliminate aside from knowing I had the HD4000 in specs.*.APPLE LOGO>ABOUT THIS MAC>MORE INFO. That solved my problem and was able to boot in Mavericks without an issue. I then deleted anything with the word ATI, INTELHDXXXX, AMD, NVIDIA, things listed as graphics.ĮXCLUDING for the ones my system was going to be using which were the INTEL HD4000. I went into System/Library/Extentions, I got rid of anything with the word bluetooth in it, didn't work. I launched Miltibeast and loaded my kexts, I was still getting a hang at bluetooth missing transport.
OPEN TRANSPORT MAC OS X MAVERICKS INSTALL
restart computer and boot -vīe patient, the 2nd half of Mavericks installation should resume now, after that you can go ahead and install your drivers(Kexts). VoodooTSCSync.kext fixes cpus=1 (enables all cores)ĮvOverboot.kext fixes the issues were attempting restart would cause the system to hang on startup.Īfter you install the 1st half of mavericks it will restart, if you boot -v it will show bluetooth missing transport or so. Here are some additional steps that will help improve performance and stability of your system
If you can't get pass the boot try using -x (Safe Mode) and see if you can at least get to the home screen and navigate. This helped prevent issues were GraphicsEnabler=No would not register using Kernel Flags parameter. In this case Ive added a rulenum of 40000 to the rule so that if you ever wanted to remove. where portnum is the number of the port you wish opened. sudo ipfw add 40000 allow tcp from any to any dst-port portnum. I use the following boot flags in order to successfully boot on 10.5.8ĭarkwake=0 npci=0x2000 PCIRootUID=1 GraphicsEnabler=No -v To create a new firewall rule to allow incoming traffic on to a particular port you can enter the rule from the Terminal as follows. Npci=0x2000 could solve the Still waiting for Root Device issue Again this is 10.8.5 version of Mountain Lion we are talking about. After some research I found out that in 10.8.5 if you are using npci= key you must set it to npci=0x2000 instead of npci=0x3000. However, I would get to home screen and the system would freeze.
Hi there.I just updated to 10.8.5 from 10.7.4 and had similar issue where it would say Missing Bluetooth Controller Transport but after waiting for about a minute the loading would continue. Building a CustoMac Hackintosh: Buyer's Guide
0 kommentar(er)
